Advice / Leaks
Burst pipe? What to do in the first 10 minutes
A burst pipe can release a lot of water very quickly. These are the steps that save the most damage, in the order to do them.

The short version
- Turn off the water at the stopcock straight away.
- Switch off the electricity if water is near sockets, lights or the fuse box, and only if it's safe.
- Open cold taps to drain the pipes, and turn off the boiler or immersion heater.
- Never use a naked flame to thaw a frozen pipe.
Burst pipes are one of the most common causes of water damage in UK homes, especially in cold snaps when frozen pipes split and then leak as they thaw. What you do in the first few minutes makes a huge difference to how much needs repairing.
The first 10 minutes
- Turn off the stopcockIt's usually under the kitchen sink, sometimes in a downstairs toilet, cellar or by the front door. Turn it clockwise.
- Deal with the electricsIf water is anywhere near sockets, light fittings or the fuse box, switch off at the mains, but only if the fuse box is dry and safe to reach.
- Drain the systemOpen all the cold taps and flush the toilets to empty the pipes. Turn off the boiler and any immersion heater.
- Find the leak and contain itPut buckets and towels down, move belongings, and wrap the burst section tightly with a cloth if you can see it.
- Call a plumberA temporary clamp or tape can slow a leak, but you need a proper repair.
The next 24 hours
- Photograph the damage and the burst pipe before it's repaired.
- Call your insurer to report an escape of water claim, and ask about drying and trace and access cover.
- Keep the plumber's invoice and any receipts.
- Don't run electrics, lights or the boiler in wet areas until they've been checked.
Why the drying matters as much as the repair
Once the pipe is fixed, the water is still in your floors, walls and ceilings. If it isn't dried properly, you can end up with stained ceilings, swollen floors and mould weeks later. Professional drying uses dehumidifiers, air movers and moisture readings to make sure the building is actually dry before anything is repaired.
How to stop pipes bursting
- Lag pipes in lofts, garages and outside walls.
- Keep the heating on low when you're away in cold weather.
- Fix dripping taps, as a slow drip can freeze and block a pipe.
- Know where your stopcock is, and check it turns.
Common questions
Is a burst pipe covered by home insurance?
The damage it causes usually is, under escape of water. Repairing the pipe itself may not be, depending on your policy.
Should I turn off the heating if a pipe bursts?
Yes, turn off the boiler and immersion heater until the leak is repaired and the system has been refilled.
How do I know if a pipe is frozen?
No water from a tap, a toilet that won't refill, or a condensate pipe outside that's iced up are common signs.
Can I stay at home after a burst pipe?
Usually, if the damage is limited and the electrics are safe. If the kitchen, bathroom or wiring is affected, your insurer may arrange alternative accommodation.



